BusinessHABPool screen repair near me: A familiar sight each season for many vinyl-liner pool owners is sags or gaps at the track that holds the liner in place. Constant fluctuations in temperature over the winter can cause the vinyl to stretch and pop out at certain spots—most often at corners or where there is plastic trim in a concrete deck that meets with the pool coping. In many cases, the vinyl can be pulled up and snapped back into place in just a few minutes. Dive in!
Read on: Pool Steps: What You Need to Know To Ensure Safety
Pool screen repair near me
1. Boil a kettle of water.
It may take several kettles, depending on the size of your liner.
- Slowly pour the hot water directly on the sagging vinyl below the top edge. Use a kettle or can with a long spout, such as a watering can.
- Do not pour onto the very top edge of the vinyl, but just below the top, because you next have to grasp that top edge.
- Pour slowly back and forth across the vinyl.
Read on: 13 Tips to Start Townhomes for Rent Business
Pool screen repair near me
2. Pull the vinyl up.
As the hot water softens the vinyl, grasp the top edge and firmly pull the vinyl up and above the track, so that when released it remains just above the track.
- It may take several cans of water before you can pull the entire edge up sufficiently.
- It may also be necessary to lower the water level 6 inches (15.2 cm) or so to increase the amount of vinyl you can stretch.
- This task is easier if one person pulls up while the other pours the hot water. But one person can do the job alone if necessary.
Pool screen repair near me
3. Re-track the vinyl.
Starting on one end, firmly twist the top edge horizontally and push it into the metal track.
- The top underside of the vinyl has a V shaped groove which should slip into a similar V groove in the top metal track.
- You should feel the edge of vinyl slip into the groove, which is supposed to keep it in place.
Read on: 19 Tips to Open Mini Salt Refinery Jobs
4. Hold the vinyl in place.
Use a large, wooden paint stirrer to help push and hold the vinyl in the track as you pull the vinyl up and into place.
- Be very careful not to tear through the vinyl.
- For longer splits use wooden clothes-pegs broken in half and placed along the split every few inches.
5. Finish up.
Upon completion of stretching and tucking, get several special short (1/4 to 1/2 inch long) plastic jamming pieces from your pool supply store, and jam them into place between the top of the plastic and the underside of the metal pool rim. This will help ensure the plastic liner stays in place.
Pool screen repair near me
6. Use an extension cord and a hair dryer or heat gun.
- Heat an area of the liner to stretch by holding the blow dryer a couple of inches from the surface and at an angle. Keep the dryer moving so you don’t burn the liner. You don’t need to superheat the liner—just get it warm enough to make it pliable.
Read on: 24 Ways to Invest in Rental Real Estate
7. Put the liner back in the track.
Done.
Pool screen repair near me
8. Use a vinyl patch kit.
A common problem with pool liners is that small holes or tears can develop from impact damage or sharp debris in the pool.
BusinessHAB